I Paper Tuned My Bow Yesterday Got The Bullet Hole I Am Looking For.

I Have Squared The Arrow To The String With Levels.

Now I Sighted It In Today At 20/30 Yards Today The Pins Are Very Close To The Riser. And I Had To Reajust The Sight It Is Very High On The Adjustment Vertically.

The Bow Shot Great Today I Was Shooting 2 In Groups At 20/30 Yards And My Broadheads Shot The Almost The Same Grouping.

I Guess The Question Is How Do I Get The Sight Adjusted Back Down So I Can Get My Sight Ring In View. Do I Raise My Arrowrest And Knock. Will That Lower My Sight?

Thanks Breck

It sounds like you need to check your peep alignment, assuming you are using a peep. A peep that's high will make you shoot high. A peep that's low will make you shoot low. You need to be sure your peep placement on the string is correct relative to your anchor point and then adjust your sight pin(s) from there.

If you are shooting arrows through paper well then you do NOT want to mess with your nocking point or your rest adjustment.

Do a search on the site for peep location. There have been a few threads in the past that provide good information on where to tie your peep in relative to your anchor point. Once your peep is tied in at the position comfortable for you then you can adjust your sights/pins to get your yardage correct.

Hope that helped.

Ron

I Paper Tuned My Bow Yesterday Got The Bullet Hole I Am Looking For.

I Have Squared The Arrow To The String With Levels.

Now I Sighted It In Today At 20/30 Yards Today The Pins Are Very Close To The Riser. And I Had To Reajust The Sight It Is Very High On The Adjustment Vertical
Thanks Breck

You need to be careful with paper tuning because you can be tuning your arrow to some fletching interferance or if your arrow are to stiff, does your arrow look like it is pointing into the riser?

yes it looks very high.

Doesn't seem right I adjusted the arrow 90 degrees from the string and paper shot it I have a vertical tear almost 1 1/2 inches fletching at the top of the tear. I adjusted the nock almost 1/2 in to get a bullet hole tear. when at full draw the arrow is not level. I am thinking the fletching is hitting the dropaway rest. I rotate the arrow and it and shoot and the paper tear looks good.