Since I'm an Audio Visual type learner, I like pictures, LOTS of pictures...

This is easier to do if you remove the actual drop away from teh bow by disconnecting it at the vertical adjusting slide. (I did not for some reason)


Remove (2) cover plate screws:
http://my.photodump.com/GSUMC_Archery/ef66726d93ee893c-T.jpg (http://www.photodump.com/GSUMC_Archery/ef66726d93ee893c.JPG.html)

http://my.photodump.com/uploads/GSUMC_Archery/f1a10429cb91e2ac.JPG


Remove cover plate by rotating anti-clockwise to relieve spring tension.
http://my.photodump.com/uploads/GSUMC_Archery/0f5b76d1d76aa635.JPG
Make note of spring orientation and set aside.


Rotate rest into up, locked position
http://my.photodump.com/uploads/GSUMC_Archery/095b2d7a9c8d66f9.JPG

Then slide the entire assembly to the outside by applying lateral pressure on the arm.

http://my.photodump.com/uploads/GSUMC_Archery/2ddc06169bf34af6.JPG

Make special not of the orientation of the square brass locking pin.
It will fit back in any of 4 ways, but will only work in one of them

It's really a walk in the park..I usually mark the top of the brass pin and the back of it(side closest to ya) with a felt marker.Some detractors make it out like some piece of voodoo:lol:

sounds great, lets see some cool looking pics of different color cords. i have one and thinking about putting a red cord on it. but what would you use?

sounds great, lets see some cool looking pics of different color cords. i have one and thinking about putting a red cord on it. but what would you use?

maybe some small d loop cord?:noidea:

http://www.youtube.com/watch?v=hJNjgk7g3Ko&playnext=1&list=PLB19E4BB8011E4907&index=59



http://www.youtube.com/user/grttaxi#p/u/29/nCGMNihQemw




Hope this helps.