Just picked up a MICRO MIDAS bow for my daughter today.
I think it is an original , meaning not a 1 or 2 .
my question is how do I adjust the draw length and
how far can i adjust the pull weight down. I dont want to adjust to much and
have the limbs fall off. Any help would be nice.

Hi,

If you look at the cams you should see holes with numbers next to them,
If memory serves me right the draw length was approx. from 18 to 28", you just have to remove the allen screw and put in proper hole measurement. Make sure you do both cams. Starting from the Limbs turned all the way down
tight. Three and a half turns is safe! The Midas 3rts package had a 6.5 inch
brace height, 32" axle to axle, weighed 2.6lbs, had a 70% let off. And a IBO speed at max draw off 275. Nice little bow. Hope that helps.

Thanks for the info, are you telling me that i can only go 3 1/2 turns
on the limbs for pull weight adjustment?
again thanks

Thats about three and half turns after you put them all the way in!