You are Unregistered, please register to be able to read posts in all forums and participate in the discussion.
Results 1 to 2 of 2
  1. #1
    Junior Member
    Join Date
    Jan 2005
    Posts
    1

    Default cutting axis shafts

    Sorry for the newbie question new to the site and have not shot for over 10 years. Just got a new bow and the dealers around here are terrible. I want to shoot axis shafts from easton but will have to order them mail order. How do you cut them? I assume a high speed cutoff saw? who sells these? Is there some attatchment for a dremel tool?
    AHA
    Rad

  2. #2
    Junior Member
    Join Date
    Jan 2005
    Location
    Morgantown, WV
    Posts
    9

    Default

    Not sure about the dremel tool attachment, but I just purchased an apple arrow saw that most dealers have in their shop. This is great because the cut off wheel will cut carbon arrows without splintering. You can contact Apple archery on their website (don't know the address), or check out 3dshoots.com online store. This saw is going to cost you over a hundred dollars, but if you cut a lot of arrows and want to do it right, you can't go wrong.

Similar Threads

  1. Cutting Carbon Shafts?
    By flintforever in forum General Archery Forum
    Replies: 5
    Last Post: 09-01-2008, 04:04 PM
  2. cutting off the back of the STS
    By Colo_Lee in forum General Archery Forum
    Replies: 16
    Last Post: 09-01-2007, 10:16 AM
  3. Easton Axis FMJ 400 Shafts
    By craig in forum Archery Equipment Accessories - Buy Sell Trade
    Replies: 2
    Last Post: 02-21-2007, 02:36 PM
  4. cutting arrows
    By Steve91 in forum Beginners Archery Range
    Replies: 2
    Last Post: 03-25-2006, 03:00 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •