Thread: Cam change questions
01-25-2010, 06:29 PM #1
- Join Date
- Jan 2010
- Southern Maryland
Cam change questions
Newby to the site. Looks like a lot of good info to digest.
I recently purchased a used DXT. It is 28/70 factory, but had a 27 cam installed. I bought a 28" cam and replaced the 27. I had it shooting good with the 27 before I changed to try to learn what effect this has. With no tuning after the change, I was shooting 2 ft low at 25yds. I checked the nock height and it was a little high. I raised the rest to re-level the nock, rather than lower the nock loop point. Then of course I had to lower the site considerably to get back to shooting flat. I guess that I have learned that changing the cam requires lowering the nock point, rather than reseting everything else. Please confirm and I welcome all comments.
By thehairlessone! in forum Bowhunting forumReplies: 25Last Post: 08-08-2009, 07:27 PM
By scottg in forum OfftopicReplies: 35Last Post: 09-20-2008, 10:25 PM
By BUNNYMAN in forum General Archery ForumReplies: 14Last Post: 06-20-2008, 11:32 PM
By Wheely in forum General Archery ForumReplies: 14Last Post: 04-13-2007, 07:30 PM
By BUNNYMAN in forum Bowhunting forumReplies: 4Last Post: 11-18-2006, 01:47 AM