Thread: Z7 tunning help?
03-21-2010, 10:22 PM #1
- Join Date
- Jan 2008
Z7 tunning help?
i was trying to bare shaft tune today with paper , i keep getting a downward diagonally left tear .
before that i tried to get the bare shafts to group with the fletched arrows the bareshafts were hitting about 2.5 " right of the fletched arrows .I moved my res over as far as i could to the riser to get that . height wise the were really close with the bareshaft hitting alittle high maybe half an inch.
iam using tt shaky hunter , beman .400 & shooting 58.8 lbs .I did read on the mathews forum that the serving is to thick & causing alot of tunning problems .just wondering if i should change my serving .
how hard is it to change serving?
03-21-2010, 10:29 PM #2
- Join Date
- Jan 2007
- South East Massachusetts
I don't know anything about the serving issue, How's the idler looking at rest and full draw?
Last edited by red44; 03-21-2010 at 10:31 PM.FBSA Member
03-21-2010, 10:31 PM #3
ServingElite bows, Vortex Binos, Trophy Taker sights, Carter releases, Goldtip Arrows. CBE sights, Vapor Trail Strings, B Stinger stabilizers
03-22-2010, 10:07 AM #4
By Cloverwolf in forum Beginners Archery RangeReplies: 2Last Post: 09-19-2008, 11:19 PM
By jag3d in forum General Archery ForumReplies: 9Last Post: 05-21-2008, 04:28 PM
By IChim2 in forum General Archery ForumReplies: 5Last Post: 01-05-2008, 03:36 PM
By jkg3117 in forum General Archery ForumReplies: 15Last Post: 09-15-2007, 09:25 PM
By MO.HICK in forum General Archery ForumReplies: 7Last Post: 06-04-2007, 08:04 PM