You are Unregistered, please register to be able to read posts in all forums and participate in the discussion.
Results 1 to 5 of 5
  1. #1
    Senior Member
    Join Date
    Jun 2004
    Location
    N.Illinios
    Posts
    309

    Default Epoxy recomendations for inserts.

    Anyone find any epoxy that is the bomb for precisely tuning broadheads and holding up in the cold conditions?
    I had some great plains stuff before and it worked alright....
    Any suggestions?

  2. #2
    Junior Member
    Join Date
    Jul 2005
    Location
    Warminster, PA
    Posts
    5

    Default Glue recommendations

    I have been using Cyber 007, made by R.S. Archery Products, inc. for 2 years to set all bushing, points, inserts. 60-80 dozen arrows yearly. rarely does this glue fail in any condition. it is not an epoxy, so there is no mixing.

  3. #3
    Senior Member
    Join Date
    Jun 2004
    Location
    N.Illinios
    Posts
    309

    Default Cyber 007

    Where can I purchase this product?
    Can I get a web address.
    Maybe I will give it a whirl,
    What is the setting time to work with?

  4. #4
    Junior Member
    Join Date
    Jul 2005
    Location
    Warminster, PA
    Posts
    5

    Default cyber 007

    www.rsbowvise.com/archery_products.htm is the web site. your local pro shop should be able to order it for you. if not the site list several folks you get purchase it from. i order mine from kinsey's wholesale.

    unlike goat tough where you only have 3 to 5 seconds this product gives you between 20-30 seconds and after 5 minutes you are ready to shoot.

  5. #5
    Senior Member
    Join Date
    Jun 2004
    Location
    N.Illinios
    Posts
    309

    Default Is 30 seconds enough time?

    I use the G5 straitening(squaring) device on the shaft and then put my insert in and square that up.When I securely screw in the broadhead to the insert or 0 ring.I then spin the arrow to see how it is true.
    Usually,ever since I have used the squaring device this method works 9 times out of ten.
    If it don't, I guess I can just try and put a different broadhead in,or O-ring and see if it spins true then.
    I was thinking of just getting some slower epoxy to spin the broadhead and insert on the shaft.
    I wonder how to square up the insert without it being on the shaft before you glue it in?
    Hot Melt it and use a marker to line it up again maybe?

Similar Threads

  1. inserts lost
    By Mathews Man in forum General Archery Forum
    Replies: 20
    Last Post: 08-03-2008, 09:28 AM
  2. Help And Recomendations
    By Defiler in forum General Archery Forum
    Replies: 22
    Last Post: 01-01-2008, 05:50 PM
  3. Recomendations for youth bow
    By Jerry in forum General Archery Forum
    Replies: 13
    Last Post: 12-01-2007, 08:32 AM
  4. Gold Tip -- best way to install inserts
    By freediver in forum General Archery Forum
    Replies: 14
    Last Post: 11-26-2007, 02:09 PM
  5. Inserts
    By fliar in forum General Archery Forum
    Replies: 4
    Last Post: 08-21-2007, 04:29 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •