Thread: tie in a drop a way rest
08-19-2007, 05:49 AM #1
- Join Date
- Aug 2005
tie in a drop a way rest
What is the proper or correct way to tie in a drop a way rest ??? does it always go on the down side cable ???? do you just put the bow on a bow press and put the cord thru the cable and then tie overhand tie to the cable ????? I know this must sound like a stupid question but how else does one learn. Thanks in advance for your help and support of my education.
BIll now 65 and still finding I sure do not know a lot about this sport of ours called archery....
08-19-2007, 06:05 AM #2
- Join Date
- Jan 2007
- South East Massachusetts
Couple different ways. Either pull it through the cable, melt the end to make a ball like you would on a d-loop, and serve above it to keep it from sliding up. Or, what I like, is to serve the area of the cable first and attatch it with same "knot" as a d-loop. If you have to do any cable twisting after you just rotate it and don't have to pull it out of the cable. Use a tied nock above it to keep it from sliding up.
08-19-2007, 10:54 AM #3
08-19-2007, 04:55 PM #4
I like running it through my down cable and melt a little ball on the end(after i get it adjusted)and than serve top a bottom real tight.If you choose to do this way make sure you serve it tight above or the preasure at full draw will pull it up the cable.
08-19-2007, 05:17 PM #5
I think I'm the only guy on the planet that uses the little "football" clamps....Pathfinder Arrow Wraps
08-19-2007, 05:22 PM #6
By MOBuzzCut in forum General Archery ForumReplies: 15Last Post: 05-18-2008, 08:41 AM
By Major257 in forum Bowhunting forumReplies: 9Last Post: 03-30-2008, 08:49 AM
By thehairlessone! in forum General Archery ForumReplies: 34Last Post: 12-21-2007, 05:02 PM
By swintj1 in forum General Archery ForumReplies: 27Last Post: 12-05-2007, 08:32 PM
By ggwash21 in forum WTB: Want to Buy Archery ItemsReplies: 2Last Post: 10-22-2006, 01:07 PM