Archery Forums 3DShoots.com
Find Archery Shoots near you  |   Advertise on 3DShoots.com

Go Back   Archery Forums 3DShoots.com > Archery Forum > Archery, How To Section
 

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-31-2009, 06:39 AM   #1
SandSquid
Uncle Sam's Canoe Club
 
SandSquid's Avatar
 
Join Date: Aug 2008
Location: 38134
Posts: 885
SandSquid is on a distinguished road
Default RipCord Rest - replacing the cord

Since I'm an Audio Visual type learner, I like pictures, LOTS of pictures...

This is easier to do if you remove the actual drop away from teh bow by disconnecting it at the vertical adjusting slide. (I did not for some reason)


Remove (2) cover plate screws:
Archery, How To Section

Archery, How To Section


Remove cover plate by rotating anti-clockwise to relieve spring tension.
Archery, How To Section
Make note of spring orientation and set aside.


Rotate rest into up, locked position
Archery, How To Section

Then slide the entire assembly to the outside by applying lateral pressure on the arm.

Archery, How To Section

Make special not of the orientation of the square brass locking pin.
It will fit back in any of 4 ways, but will only work in one of them
__________________
SandSquid

Gone camping in the mountains of Afghanistan.
Will return sometime in early/mid 2012.
SandSquid is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:17 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2004 3DShoots.com