Archery Forums
Find Archery Shoots near you  |   Advertise on

Go Back   Archery Forums > Archery Forum > General Archery Forum

Thread Tools Display Modes
Old 01-25-2010, 05:29 PM   #1
Junior Member
Join Date: Jan 2010
Location: Southern Maryland
Posts: 2
rainhellfromabove is on a distinguished road
Default Cam change questions

Newby to the site. Looks like a lot of good info to digest.

I recently purchased a used DXT. It is 28/70 factory, but had a 27 cam installed. I bought a 28" cam and replaced the 27. I had it shooting good with the 27 before I changed to try to learn what effect this has. With no tuning after the change, I was shooting 2 ft low at 25yds. I checked the nock height and it was a little high. I raised the rest to re-level the nock, rather than lower the nock loop point. Then of course I had to lower the site considerably to get back to shooting flat. I guess that I have learned that changing the cam requires lowering the nock point, rather than reseting everything else. Please confirm and I welcome all comments.
rainhellfromabove is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:32 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2004