2010 Hoyt Alphamax35, Custom w/ both Z3 and XTR cams....

[ohbowhntr]

I have a 2010 Hoyt Alphamax35 that was a Hoyt Custom build with Z3 cams. This is a 28.5" DL bow, pulls about 73# when maxed out, and is about 5-6fps faster than the bow is with the original XTR cams that come standard on MOST AM35's. I also have a set of XTR cams and strings that can go with the bow with the 28.5" Mod. This cam set with these strings is adjustable from 27-29" with other mods. As the bow sits with the Z3 cams, you can tweak the cables and get about 1/2" DL above or under the 28.5" that it is set at. Bow, extra cams, extra strings, peep, kisser, speed balls on the strings.... $550 TYD The bow is in near mint shape, I'd rate it a 9.9/10, draws and shoots AWESOME, but my shoulders are not getting any younger. I'm keeping the 60# bow I have that is set up exactly like this one with Z3 cams.

Add NAP QT4000 Micro-adjust Drop-away and RT 1100 Bone Collector Sight and make it $625 TYD

Bow...


Grip.... Note no wear on the camo at all, where these bows typically get some wear.


Standard Grip (I also have a Hoyt 180 Grip if you'd rather have the 180 grip...)


There is a TINY set-screw mark on the side of this bow, but I can't get my camera to take a picture to show it because it is that small, here's the closest I could get...


Hoyt 180 Grip on another bow which I can swap out, it's also in EXCELLENT condition....

[ohbowhntr]

Back TTT....

[ohbowhntr]

Back up for an AWESOME custom set-up. I think my 64# bow that is set-up the same as this shoots about as fast as my other 70# AM35.... Not sure how fast this one is as I've never chrono'd it, but it should be 322 IBO.

[ohbowhntr]

$475 barebow, $550 set-up with the Z3 cams, or $625 w/ both sets of cams, extra strings, etc....

[ohbowhntr]

$450 TYD barebow....$525 set up...

Low as I can go.....

[ohbowhntr]

Back to the top....

[ohbowhntr]

Back to the top again....

Either bow for $450 TYD bare, or I can set up either bow in an assortment of ways to fit your needs. With a little cable tweak either bow will easily be a 28" or 29" draw, but that will be the maximum adjustability of them without cam and string swap. Bare bow with a set of XTR #2 cams and a 28.5" mod (adjustable from 27-29" $550.

[diesel094]

hey can you do me a favor?

Im looking to make a grip similar to the one on your bow... can you tell me the dimensions of the grip?

Hole diameter
distance of hole from the top of grip
length of grip
height of grip
width of grip

width of riser