drop a way rest question

sweet old bill · 07-21-2012, 03:36 AM

How do you attach the drop a way rest cable to the bow down cable ? do you just tie it on, or do you have to press the bow to put the rest cable thru the bow cable ? or is there a part that I have to buy ? I have on the other bow a drop a way rest but it attached at the cable slide....

tuckerman9 · 07-21-2012, 06:45 AM

You can use a clamp to attach to the down cable or you can separate the cable and put it threw it but u still need to use serving thread to to secure it from moving. I like using the clamp. Ripcord calls theirs a FOOTBALL clamp, and that is the one that I use.

duanelane · 07-21-2012, 01:04 PM

Ihave mine tied to the down cable with the same knot you use for a d loop. Ihave used serving thread and served the rope on to the down cable to .

red44 · 07-24-2012, 10:57 AM

Via the D-loop method also. Never need to press the bow or split your cable.
Serve a couple of inches of cable, tie a nock on it, do the D-loop below the nock. simple.

Jodyb · 07-25-2012, 01:27 PM

go to youtube and type in QAD ulta rest instilation there is a good video on how to attach your lanyard to your cable

bowman90 · 07-27-2012, 03:45 PM

I dont have to worry about all of that. Cause I have a limb driver. They are alot simple than other rests to tune.

wilkersonhunter · 07-28-2012, 06:20 AM

Quote:

Originally Posted by bowman90

I dont have to worry about all of that. Cause I have a limb driver. They are alot simple than other rests to tune.

Aaahhh I've taught you well young grasshopper

Outdoor Hub mobile, the outdoor information engine