|
|
| Find Archery Shoots near you | Advertise on 3DShoots.com | |
07-25-2007, 11:00 PM
|
#1 |
|
Member
Join Date: Jul 2007
Location: East Texas Piney Woods
Posts: 38
 |
Fletching Jig
Do any of you have any information on the Bohning Tower Jig? The package I have seen does not say if it does left or right helical, it does say it put's the vanes at a 2 degree angle.
|
|
|
|
07-26-2007, 07:28 AM
|
#2 |
|
Member
Join Date: Oct 2005
Location: Michigan
Posts: 60
|
I'm not sure. Ive been looking everywhere for it but it seems no one carries it!!!
__________________
Martin Cougar III SE Dyna Cam, Gold Tip XT arrows, Trophy Ridge Matrix 5-pin, Red Hawk Low Light Peep Sight, STS, Trophy Taker, S-Coil, Limsavers  Genesis 27:3 Now therefore take, I pray thee, thy weapons, thy quiver and thy bow, and go out to the field, and take me some venison; 
|
|
|
|
|
07-26-2007, 09:44 AM
|
#3 |
|
Member
Join Date: Jul 2007
Location: East Texas Piney Woods
Posts: 38
|
I called Bohning and told them that the package only says 2 degree offset but not left or right. They told me it was a right offset. So, I went down and bought it at the Acadamy outdoor store for $44.99. It is some cheaper than the other three vane jigs. Time will tell if it is any good.
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -5. The time now is 08:11 PM.