9.3's

Discussion in 'General Archery Forum' started by sleepytrucker, Dec 15, 2007.

  1. sleepytrucker

    sleepytrucker Junior Member

    33
    0
    0
    does anyone here shoot 9.3's with pin nocks. if so do u use the pin adapters with the uni-bushings or have u found adapters that go directly into the shafts. thanks
     
  2. Long Draw

    Long Draw Banned

    221
    0
    0
    I shoot 9.3's for 3D. They are generic Fatboy's. I dont use pin nocks, I use QAD tun a nocks for better FOC. Sometimes Easton component charts refer to Easton brand only, but all Fatboy components are 100% interchangable with the Beman 9.3's.
     

  3. Chris

    Chris Administrator Staff Member

    4,078
    5
    38
    I was told the Goldtip .246 pin nock adapter will fit. I haven't tried it myself though.
     
  4. Ronhop

    Ronhop RIP

    3,967
    1
    0
    How in the world do you get the bushings out of a Fatboy without damaging the shaft ? I'm still a little confused as to why Easton/Beman don't have a nock end of the shaft option(s) for the fat shafts. Heck, they make you buy the inserts, nocks and points separately but they glue in the busings at the factory. That don't make much sense to me.

    Ron
     
  5. Chris

    Chris Administrator Staff Member

    4,078
    5
    38

    I was told, leave the bushing. Insert the goldtip pin nock adapter into the bushing.