bowtech allegiance draw length?

Discussion in 'General Archery Forum' started by bowcrzy39, Sep 3, 2008.

  1. bowcrzy39

    bowcrzy39 New Member

    1
    0
    0
    i replaced the strings on my bow and the ata,bh were way off! i set all the measure ments back to factory specs. is what i need help with is how to determine the bows actual draw lenght because it seems to feel a little longer than it was THANX!:mad:
     
  2. PA.JAY

    PA.JAY New Member

    213
    0
    0
    Bowtech run around 1/4 long on the draw.
    I'm sure you can put more twist in the string find away to pull them to 100 pounds & measure it then.
     

  3. harleyryder

    harleyryder bowhunter, Pure-n-Simple

    156
    0
    0
    did you replace them with factory strings or custom ? Reason why I'm asking is if you have a string(and cable) that is smaller in dia. then it will make you draw lenght a tad bit longer as where the ones I got the maker had added a strand(????) and the draw was shorter plus it was to large for the cam groove