Trykon Tunning

Discussion in 'General Archery Forum' started by jag3d, May 18, 2008.

  1. jag3d

    jag3d New Member

    3
    0
    0
    Hi there
    I am new here:wave:
    reason is ..that i like some help whit my paper tuning.
    I love 3d shooting .
    so i am seting up my Trykon for it
    Problem is the tuning,
    I am susing a 50-60pound 29 1/2 draw Trykon
    and carbon express 3d sellect maxima 250/300 spine
    But what ever i try ?? left tear 45 degrees 3 inches long
    I'ts driving me nuts ,:frusty:
    I must be doing someting wrong :noidea:

    Can some one please give me some tips
     
  2. BowhuntnHoosier

    BowhuntnHoosier Bisquit.......

    13,887
    15
    0
    :welcome: to the forum. Sorry but I don't put much faith into paper tuning. But I am sure if you give it time someone will come along and help ya out. HCAman has a Trykon maybe he will show up and help out.

    Again I would like to say WELCOME and hope you enjoy yourself here.:peace:
     

  3. archer1983

    archer1983 New Member

    837
    1
    0
    what kind of a release are you using?
     
  4. Hook Em

    Hook Em Slippy for President

    1,938
    0
    0
    Welcome to the site! Not trying to discourage you, but the only way I could paper tune my Trykon was to move my rest as far as it would go to the left....of course you wouldn't want to shoot it like that. Just set the center shot the best you can and walk back tune. Paper tune schmaper tune!
     
  5. TEN RING

    TEN RING ONE SHOT ONE KILL

    489
    0
    0
    you may have some flecthing interferance
     
  6. jag3d

    jag3d New Member

    3
    0
    0
    Hey

    I am shooting with a carter holething release,and a D loop .
     
  7. tnts79

    tnts79 Senior Member

    1,014
    0
    0
    ?

    x2 Sounds like fletching contact.:noidea:
     
  8. J.Blay

    J.Blay New Member

    671
    0
    0
    I shoot an ultra mag. at 60# with a 29" draw. I had the same problem when I went from CX 300 shafts to terminator LT. 4560's. The chart showed that they were within specs., but I had to adjust my rest way out to get a decent tear in the paper. I switched to terminator LT. select 6075 shafts and the problem went away. If you're stuck on the more expensive maxima's, try the 350 shaft's. If not, the terminatoer Lt. selects are made to the same straightness and weight differance standards as the maxima, and only cost me 70.00 a doz.
     
  9. jag3d

    jag3d New Member

    3
    0
    0

    Hi

    yes i also read on archery talk that some one used ultra stif arrow's and a foc 7/9 %
    Ill try the 350 Maxima ,and see what that brings
    thanks for the responce.
     
  10. tnts79

    tnts79 Senior Member

    1,014
    0
    0
    I shoot 5575 gold tip xt's at 65 lbs. and a 29" draw 100 gr. head, and mine punches bullet holes??:noidea: