I have a Guide Series Tec Hunter Elite made by Bowtec for Gander Mt. My cables are 35.5" at the top of the bow the cable is split and fastened to the bow. How do I make this type of cable. :frusty:
You lay it out on your string jig like a regular string, but you when get ready to serve the loops on the yoke end, you remove half the strands, serve about a two inch section, then swap it for the other half serve two inches, then serve the loop. Then swap back and serve the other loop. That wasn't too confusing, was it? :biggrin1:
Thank You No, I guess not since you explained it, I can now see visualize how it is done. eace: :rockon:
Thank You No, I guess not since you explained it, I can now see visualize how it is done. eace: :rockon: What is the size of the loop need to be?