What are your thoughts on using a limb driver rest for spots???

Discussion in 'General Archery Forum' started by beenfarr, Aug 29, 2007.

  1. beenfarr

    beenfarr Senior Member

    956
    0
    0
    Just wondering if it's a bad Idea???


    Ben
     
  2. Ronhop

    Ronhop RIP

    3,967
    1
    0
    I don't think it's a bad idea as long as you set it up and tune the rest/bow/arrow correctly... It's just like any other rest install. You need to fix clearance issues and make sure nocking point and center shot is right...


    Ron
     

  3. HYTMANN

    HYTMANN Senior Member

    136
    0
    0
    Limb Driver For Spots

    So far, so good!! I've been using one for 3D and spots since April. It was very easy to set up and seems to be a forgiving rest, best features of both a tuner and a drop away, without the clearance issues of a tuner, even with Spin Wings. To make the drop away cord more durable, drop a #6 or #5 lead shot down the hole for the set screw that secures the cord to the arm, the set screw will cut through the cord if over tightened otherwise. :thumb:
     
  4. red44

    red44 Senior Member

    2,342
    12
    0
    With the limbdriver I left the cord long, and after I had the rest all set up, I pulled the extra back up onto itself and tied a nock around both. I can pretty much remove the screw. (just another way of securing the cord without over tightening the set screw.)
     
  5. Cameron

    Cameron Senior Member

    803
    0
    0
    Contact Meanv, he has them in stock.
     
  6. beenfarr

    beenfarr Senior Member

    956
    0
    0
    If I go limb driver I will. :rockon:

    Ben
     
  7. Cameron

    Cameron Senior Member

    803
    0
    0

    How many Slingbraids does that cost?:laugh:
     
  8. Archerdad

    Archerdad Senior Member

    896
    4
    0
    most of those guys use a spring steel launcher type rest.

    very simple and pretty fool proof.

    i am sure you would see a lot of different rests if you went and watched an indoor shoot.

    they all work when used and setup correctly.
    shoot what you want.
     
  9. beenfarr

    beenfarr Senior Member

    956
    0
    0
    about 9!!!:laugh:

    Ben